From the participant's profile page, navigate to the Complete a Visit tab. Enter your initials under the scan you'd like to collect (Brain Age or Cognition Tracker). Then click “Capture Brain Age/Cognition (Visit 1)/Cognition (Visit 2)”.
The Flow Interface opens.
If the headset has already been initialized, a map of functioning Flow modules appears, and the only option is Turn Lasers ON.
If the headset has not been initialized, the Flow Interface will prompt you to do so. The headset must be on the stand with lights off to complete initialization.
NOTE:
We recommend powering on and initializing the headset before the participant arrives. See Starting up the Flow System for details.
Before clicking Turn Lasers ON, place the headset on the participant. See Place the Flow headset on the participant for best practices. See the video below for a summary.
If running the Cognition Tracker, connect the EEG Ref and Bias cables to the participant's earlobes. See Connecting the EEG components for details.
Click Turn Lasers ON to activate the light sources.
Optimize signal quality. See Getting the Best Signal for more detail.
Begin by gently tugging the ear covers outward and shifting the headset side-to-side or in figure-eight motions to comb the light pipes through the participant’s hair. Be cautious not to use downward force when doing so.
Often, the best results come when the participant manipulates the headset themselves. Ask them to place their hands on the back of the headset and perform the movement for no more than 60 seconds, or until signal percentages stabilize within ~5%.
Verify headset placement. On the left side of the signal map, the Portal Flow Interface shows four images illustrating proper and improper placement. Ensure the headset is centered, the white arrow is aligned between the eyebrows, level, and resting on the eyebrow line. Ask the participant to adjust if needed.
Tighten the headset slowly using the tension dial. Stop when the participant first feels slight pressure. Do not over-tighten, as this can become uncomfortable over time.
When the headset is correctly positioned, press Continue. Ask the participant to remain still for 15–20 seconds while the device calibrates.
The system advances to the Recording screen. On this screen, you’ll see several metadata fields, most of them autofilled.
Review real-time data quality indicators to the right of the metadata panel:
Signal: Overall signal quality. If a yellow warning symbol appears, refer to the Signal Quality page for adjustment tips. You may toggle lasers off and back on to re-check alignment.
Excess Light: Possible interference from ambient light. If flagged, darken the room or block light sources.
Motion: Participant movement detected. If flagged, remind them to remain still.
When ready, press Start Recording. This opens a new browser tab. Click Start to begin the task.
When the task ends, the participant will see the lavender completion screen. Exit full screen, close the tab, and in the Flow Interface, press Stop Recording.
Click Turn Lasers OFF. At this point, remove the headset according to the instructions in Removing Flow from the participant and press Back to Visit to return to the profile page.
You will see on the Profile page that the step is marked with a "Flow Recording Completed" message. You always have the option to collect further scans by entering your initials once again.
Sanitize the headset according to the instructions in Cleaning your Flow system.
Power down the headset using the On/Off Switch on the Power/Data cable.